Ms-systems WG150W Bedienungsanleitung

In-Wall & Ceiling Speakers Owner’s Manual Part Numbers WG100C WG100W WG150C WG150W WG Series 115986D.pdf 1115986D.pdf 1 11/

highest directional response in this direction. See figure 5. If you want to disperse the sound in a 360-degree pattern you must position the lin

In-wall Speakers Step 1. Speaker mounting rings are used in the pre-construction phase of speaker installation during construction of new homes and a

• Do not install the actual speaker until the wall board is in place. Until then leave several feet of wire secured to the back of the mounting ring.

Step 3. This is the finish-out stage. Prepare the speaker wiring by stripping off approximately 3 inches of the outer jacket (care should be taken so

Page 14 the baffle using the 6 screws provided. DO NOT OVERTIGHTEN THE SCREWS, the screws should on only be tight enough to secure the speaker. Step

Page 15 Step 7. Divide each adhesive bead strip in half. (Adhesive bead strips are in the clear self-closing bag). Place strips on the edge of the gri

Page 16 for Existing Construction Ceiling Speakers For existing construction, the use of mounting rings can not occur. The following steps outline ho

Page 17 deep enough to fully penetrate the drywall. Step 4. Obtain a length of stiff wire such as a straightened wire coat hanger. Bend it so that th

Step 10. Follow the instructions included with the volume control and amplifier. Step 11. You are now ready to install the speaker. Remove the paint

pattern you must position the line in the tweeter in a horizontal position. See figure 5 on page 10. The combination of switch settings allow you to

Page 2 Introduction WG Series ceiling and in-wall speakers are designed to provide clear, sharply-focused audio reproduction while remaining unobtrus

When the sound is sharper and more flat sounding, you are close or over a stud. • Identify studs by the position of electrical outlets or switches.

you do not cut the hole larger than the outline. Step 7. Be sure to clear any insulation material from the speaker back. Step 8. After you have det

none of the strands from the black and red wires are touching each other. This can create a short circuit that can damage your electronics. Mount the

Page 23 WARRANTY M&S Systems™ Limited 10-Year Warranty for WG Series Speakers and AirVac™ Gold Power Units M&S Systems offers a 10-Year Warran

800.421.1587 www.mssystems.com Service & Troubleshooting M&S Systems is committed to producing high quality audio products for the home. If y

Page 3 WG150C Ceiling Speakers (Sold in Pairs) WG100W In-wall Speakers (Sold in Pairs) Page 3 Frequency Response 35Hz to 20kHz (+/-3db) Maximu

WG150W In-wall Speakers (Sold in Pairs) Unpacking Your Speakers Before you unpack your speakers, be extra careful not to touch the cone and twe

foot ceilings and above) apart but no closer than 2 feet to any adjacent wall. Avoid placing speakers in air return cavities. Some type of protectio

of the speaker, use a piece of bat insulation at least 3 inches thick in the stud cavity. This insulation should not have a backing or if it does, th

TIPS FOR NEW CONSTRUCTION • If possible, run speaker wires after AC wiring is in place to avoid additional noise caused by close proximity of wiring

installed. Leave at least 18 inches additional ca-ble for the connection during final speaker instal-lation. Run the other end of the speaker cable to

tweeter when removing the paint mask in order to prevent any damage. Attach the speaker cable to the speaker by pressing down on the red (+) or blac